Search found 6 matches

by unicyclist
Mon May 21, 2007 7:38 am
Forum: Off-Topic Hobbies
Topic: I just bought a truck
Replies: 9
Views: 2171

If worse comes to worse, give a little bit of a tip. I have never failed inspection. :D
by unicyclist
Sun May 20, 2007 1:06 am
Forum: Off-Topic Hobbies
Topic: rifled bullet
Replies: 11
Views: 9462

So to some extent, a rifled bullet spinning in air is the (close to) the same as a smooth bullet because there is no friction from the barrel anymore. Right? A rifled barrel and bullet makes the most sense to me. The barrel to get it started, the bullet to keep it going. With a smooth bore and a rif...
by unicyclist
Sun May 20, 2007 12:40 am
Forum: Off-Topic Hobbies
Topic: rifled bullet
Replies: 11
Views: 9462

rifled bullet

Ok, so I think I understand how a rifled barrel works.

But what I'm pondering today is what if the bullet was rifled and the bore was smooth? Or both the bullet and the bore were rifled?

I'm sure it would take a lot of work to rifle a bullet, but would it go faster, farther, etc?
by unicyclist
Sat May 19, 2007 11:44 pm
Forum: Pneumatic Cannons
Topic: Piston Valves Explained Visually
Replies: 178
Views: 302148

what is the most common?

what is each type used for?
by unicyclist
Sat May 19, 2007 2:57 pm
Forum: Off-Topic Hobbies
Topic: Sig Hall Of Fame!
Replies: 31
Views: 6163

super spuder wrote:myn is just a list of some of the things people have said to me / told me. I am going to run out of room soon. :lol:
lmao


My sig on the other forum I use is "It takes twice the man to ride half the bike.
by unicyclist
Fri May 18, 2007 11:58 pm
Forum: Pneumatic Cannons
Topic: Modding A Sprinkler Valve
Replies: 191
Views: 283941

how is this valve? I have seen just about every valve on here but this one.

[albumimg]327[/albumimg]
[albumimg]326[/albumimg]

would it be ok to remove the solenoid and drill right through that? From what I have read the rod is on the bottom, which is a good thing right?