cast brass fittings
-
SilentCyan
- Private 2
- Posts: 31
- Joined: Mon Jul 21, 2008 1:11 pm
would there be any problems using cast brass fittings in a homemade stirrup pump? i'm using 3/4" copper so chances are i'm not going to be using it over 300psi
-
Mr.Sandman
- Corporal 3
- Posts: 762
- Joined: Fri Mar 28, 2008 9:10 am
- Contact:
umm no why do you think there would be problems? Unless they had no threads then you would have to solder them. but plenty of spudders(including me) do that when we make cannons so you should be fine.
Yeah, it's that important.
-
SilentCyan
- Private 2
- Posts: 31
- Joined: Mon Jul 21, 2008 1:11 pm
i just wasn't sure if the fact that they were cast would make any kind of difference as to how much pressure they could hold so i figured i'd check just in case. but after seeing your answers i went out to lowes and bought all the pieces i need for a pump. should have it made by tomorrow 
and shortly after should be a copper gun to utilize it's full potential.
and shortly after should be a copper gun to utilize it's full potential.
Cast means it was poured from molten metal. When its not cast its usually machined, or extruded.