Potatoes last one shot, so build reusable! Discuss ammo designs and ideas. Tough to find cannon part or questions? Ask here!
-
achs_xc
- Private
- Posts: 15
- Joined: Mon Jan 26, 2009 8:27 am
Mon Nov 30, 2009 9:01 pm
In a coaxial gun that is 12" or greater is there a need to have the barrel supported by something? Is there an optimal length to use? I am having a hard time visualizing it.
-
achs_xc
- Private
- Posts: 15
- Joined: Mon Jan 26, 2009 8:27 am
Mon Nov 30, 2009 9:17 pm
No...sorry. I have a 1/4" brakeline that is 18" long. Using 3/4" copper pipe as the chamber, is there a need to have the piston side of the barrel supported?
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
Mon Nov 30, 2009 11:43 pm
Depends how stiff your barrel material is, don't forget that the force is parallel to the barrel and therefore unlikely to bend it if the launcher is built correctly.
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
qwerty
- Corporal 2
- Posts: 678
- Joined: Sun Apr 12, 2009 2:16 am
Tue Dec 01, 2009 2:53 am
To anwer you question- a coaxail just means that the barrel is inside your chamber. To hold the barrel in the middle of the chamber i just glue on small peices of balsa.
I visit occasionally to make unrelated posts.
-
kenbo0422
- Specialist 2
- Posts: 201
- Joined: Mon Oct 06, 2008 7:33 am
- Location: East Tennessee
Tue Dec 01, 2009 6:51 am
To keep the alignment intact and to keep it sealing and firing consistently you'll want to support the end of the barrel inside the chamber. Epoxy and nails, or if you can solder, use a couple of slices of that copper pipe
