Page 1 of 1
How to connect metal barrel to PVC chamber?
Posted: Sat Sep 21, 2013 7:47 pm
by Cy4ka
I'm looking for a way to connect a 2.5" steel pipe for a barrel to a 6" PVC chamber. I have no idea how I'm going to do it. Does anyone here have any ideas? I'd be nice to find thin wall 6" or even 8" steel tubing and then I'd just weld it (I wanted the whole thing metal to begin with).
Posted: Sat Sep 21, 2013 7:54 pm
by dart guy
ask epoxy man,that is jsrand some one should make a parrody of cinderella man by eminem for him because he is up with chuck noris and god because of his balistic knife.i am thinking endcap filled with epoxy
Posted: Sat Sep 21, 2013 9:46 pm
by velocity3x
dart guy wrote:ask epoxy man,that is jsrand some one should make a parrody of cinderella man by eminem for him because he is up with chuck noris and god because of his balistic knife.
OK......So how much is Jsr paying you to praise him?
Posted: Sat Sep 21, 2013 10:37 pm
by Gippeto
More details would be nice...combustion (I suspect so.) or pneumatic?
McMaster Carr show a 6" to 3" reducer bushing and a 3" to 2 1/2" reducer bushing.
http://www.mcmaster.com/#plastic-pipe-fittings/=om1fvt
Would then have to adapt your steel pipe to the pvc bushing...perhaps using a threaded reducer bushing for the 3" x 2 1/2" and adapting to that?
Velocity...haven't you ever had a puppy?
Posted: Sun Sep 22, 2013 12:38 am
by velocity3x
Gippeto wrote:Velocity...haven't you ever had a puppy?
A Puppy...yes but that post sounds like "Thunderlord".
Posted: Sun Sep 22, 2013 9:37 am
by dart guy
i cant remember whos quote it was check in a jsr balistic kife post
Posted: Sun Sep 22, 2013 7:15 pm
by Technician1002
Threaded pipe and threaded fitting.. Screw it on.
Mine are similar with plastic barrels and metal chambers. Concept is the same.
