In bb guns like the sniper rifle, how can it shoot at least 5 shots without
spending all the air in the chamber?
and why only 1 shot doesn't taking out all the air?
a question about bb sniper rifles
- jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
When you take a shower, you don't drain the entire water system the second you open the tapelad311 wrote:and why only 1 shot doesn't taking out all the air?
If you have a valve that opens and closes instantly (like say, a hammer or manually operated blowgun valve), it will only release a small amount of the pressurised air in the chamber, leaving enough air for subsequent shots.
hectmarr wrote:You have to make many weapons, because this field is long and short life
Is this valve DIYable?jackssmirkingrevenge wrote:When you take a shower, you don't drain the entire water system the second you open the tapelad311 wrote:and why only 1 shot doesn't taking out all the air?
If you have a valve that opens and closes instantly (like say, a hammer or manually operated blowgun valve), it will only release a small amount of the pressurised air in the chamber, leaving enough air for subsequent shots.
- jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
Refer to your other thread. - All you need is a blowgun with a chamber at one end and a barrel at the other.elad311 wrote:Is this valve DIYable?
hectmarr wrote:You have to make many weapons, because this field is long and short life
But blowguns don't open fast!jackssmirkingrevenge wrote:Refer to your other thread. - All you need is a blowgun with a chamber at one end and a barrel at the other.elad311 wrote:Is this valve DIYable?
- jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
Ah, but everything in life and spudding is relative. You wouldn't use a blowgun as a main valve for a 2 inch calibre cannon, in that case yes, blowguns don't open fast! When it comes to 6mm BBs however, with enough pressure behind them and a long enough barrel, a simple blowgun could be enough for your purposes.elad311 wrote:But blowguns don't open fast!
If it can put a lead pellet through a tin can at point blank range as shown in the other thread, then it is certainly good enough for airsoft sniping. What sort of performance are you expecting from this design? If you want multiple shots from one chamber and don't have too many resources in terms of HPA/CO<sub>2</sub> tanks, chances are you're going to have to make a compromise when it comes to performance anyway.
hectmarr wrote:You have to make many weapons, because this field is long and short life