SpudFiles

hey guys i need to finish a piston valve by the end of this week, and from previous experiences im going to make it serviceable.
how do i do this? do i just put in the end cap and put some screws in there, how will that make it air tight,

look in the showcase there are many ways. Pick your favorite.

http://www.spudfiles.com/forums/viewtop ... tml#240585
Pretty basic idea how to build my current valve

and my old one which is simple as well,
http://www.spudfiles.com/forums/how-i-b ... ter,0.html

jmeyer1022 wrote:http://www.spudfiles.com/forums/viewtop ... tml#240585
Pretty basic idea how to build my current valve

and my old one which is simple as well,
http://www.spudfiles.com/forums/how-i-b ... ter,0.html

ty, i am actually using a 2", 1.5" piston

jmeyer1022 wrote:http://www.spudfiles.com/forums/viewtop ... tml#240585
Pretty basic idea how to build my current valve

and my old one which is simple as well,
http://www.spudfiles.com/forums/how-i-b ... ter,0.html

not to be rude, but i know how to build everything except how to make it serviceable, can i just use screws to hold in the plug

covey12 wrote:hey guys i need to finish a piston valve by the end of this week, and from previous experiences im going to make it serviceable.
how do i do this? do i just put in the end cap and put some screws in there, how will that make it air tight,

With the right size pipe in a female adaptor for the piston, it could be put in as an assembly with a removable plug. My Mouse Musket 1 inch coaxial uses this as well as my Dragon with a 2.5 inch barrel and 3 inch piston.

Attached is a photo of the breech open on the Mouse Musket. This would work in a T.