SpudFiles

Any body have any good homeade dart ideas that fit nicely in 1/2 inch copper tubing?

Nail with a paper cone glued on.

Thanks GUn freak

Anytime

Paper cones are not for high presures.
You can use nail with pen cap filled with hot glue.
This is what i made,but dont use so much glue or the dart will start tumbling.

http://s1081.photobucket.com/albums/j35 ... 011175.jpg

Also,you can make them using this method.
http://www.youtube.com/user/theairgunma ... hbijG4FKSk

I've seen members use the tips off of caulk tubes with nails. Seemed to work pretty good.

@ Doctore, I love your idea !!!, Ill have to try that

But Doctore, what size barrel are you using, Im planning on using 1/2 inch copper tubing,Im using it right now for my double a battery shooter, but like to try differnt ammo!!! =)

Edited by jrrdw.

Well I am using plastic pipe,a little bit smaller than 1/2 inch copper tubing.If it doesnt fit correctly just wrap it with electrical tape.
The second method is also good,but little harder to make.

Another idea, take a length of 1/2" pipe, and fill it with water, then stick in the freezer over night. Done, premade ice ammo, and I hear it works really well. Plus as it melts it greases up your barrel so it moves faster.

Melting ice turns into grease? I learn something new every day

No it doesn't turn to grease.... I mean it lubricates the barrel... :banghead:

Its inaccurate,and you have to carry freezer with you

Doctore wrote:Its inaccurate,and you have to carry freezer with you

Unless of course you're a champion micro ice sculptor. :laughing6:

i found a sewing thimble once and put a nail through it. it fit perfectly in my barrel but mine was pvc it worked awesomley, but i only has one and i lost it

I've had pretty good success with these

edit: looks like doctore beat me to it