Page 1 of 1
pilot valve for 300 psi?
Posted: Sun Oct 21, 2012 1:08 pm
by GustavssonB
Were can I find a small pilot valve that I can use to trigger my QEV.
I want it to be able to work at 300 psi (20bars) pressure.
The current valve I´m using is a simple ball valve, witch I think is to big and it doesnt feel as a trigger.
Posted: Sun Oct 21, 2012 1:51 pm
by jsefcik
check ebay or mcmasters
personally id say go with a pneumatic relief valve, they are aluminum and will launch golf balls out of sight in seconds!and with these valves its already piloted!
these valves im talking about are inch and half
Posted: Sun Oct 21, 2012 4:09 pm
by PVC Arsenal 17
Is this gun connected to a constant air source? If so, the MJVO-3 has been proven at those pressures. A slide valve is always good too.
If you have a "fill here and shoot over there" setup then you can use a pistol-grip blowgun for that trigger feel. What size QEV is this? A good modded blowgun can handle a 3/4" QEV with no trouble.
Posted: Mon Oct 22, 2012 9:45 am
by GustavssonB
It's a one shot Gun, i want a simple blow gun, but in Sweden i can only find blow Guns that is pressure rated to 10 bar:/
Posted: Mon Oct 22, 2012 9:46 am
by GustavssonB
The qev is 19 mm in diameter:)
Posted: Mon Oct 22, 2012 9:47 am
by jackssmirkingrevenge
GustavssonB wrote:in Sweden i can only find blow Guns that is pressure rated to 10 bar:/
they usually work to 30 bars though
http://www.spudfiles.com/forums/micro-b ... 18270.html