SpudFiles

So here is my first attempt. It is a 300psi pressure washer gun trigger with 1/4" ID stainless tube threaded in, breach load single shot. I run it of my 100psi compressor as I only intend to fire it in my workshop for target shooting. Ammo is 1/4" steel ball bearings. Magnet on left side is ammo mag and magnet on right side to stop ball rolling out of barrel before shot is taken. Adjustable grip is from angle grinder, there was a small amount of welding, everything else is hand made.

Cost = $0

Is this just a pressure washer with a barrel attached to it? Likin the countertop BTW

Yes, just a standard pressure washer gun, I got 3 of them out of the rubbish bin at work, they have a 1/4"' pipe thread in the end. Perfect for pneumatic triggers.

I made the countertop aswell out of pineboard.

Looking good!
Do you have some videos of it in action?
This is screaming for high pressure

I'm going to video the full auto to get the fire rate, so I could do this one as well.

The magnets might be detracting from accrurecy. They really need to be placed above the bb to be of any use/benifit. Research magnisun effect. Not sure that's how its spelt

Interesting, I hadn't thought about that