My COmbustion CAnnon

Boom! The classic potato gun harnesses the combustion of flammable vapor. Show us your combustion spud gun and discuss fuels, ratios, safety, ignition systems, tools, and more.
Post Reply
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

Mon Nov 06, 2006 9:13 pm

hey Guys

well its been a little while since ive been building. Took a bit of a break sold all my cannons too friends. money was very tight. But im building another combustion. Its like a modded version of pete zaria's basic reliable cannon with the propane meter and stuff. Anyways what type of bit should i use to Pilot a hole to hand screw 3/4'' brass nipple to.



THanks
Haylo_stealer
Last edited by HAYLO_Stealer on Mon Nov 06, 2006 9:19 pm, edited 1 time in total.
Top
User avatar
SpudStuff
Sergeant 5
Sergeant 5
Posts: 1410
Joined: Sat Dec 10, 2005 3:55 pm
Location: Cupertino, California
Contact:
Contact SpudStuff

Mon Nov 06, 2006 9:17 pm

1" Should do the trick if you drill it perfectly streight.
Top
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

Mon Nov 06, 2006 9:18 pm

I should be able too so 1'' bit should to it
Top
User avatar
SpudStuff
Sergeant 5
Sergeant 5
Posts: 1410
Joined: Sat Dec 10, 2005 3:55 pm
Location: Cupertino, California
Contact:
Contact SpudStuff

Mon Nov 06, 2006 9:21 pm

Yes, the pipe is 1.050" OD.
Top
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

Mon Nov 06, 2006 9:23 pm

where can i get a 1" bit and about how much do you think it would put me out.
though im going to rip of lowes anyways. Ill buy it use it refund it.
Top
Post Reply

Return to “Combustion Cannons”