Page 1 of 1
what would this be like?
Posted: Thu Jun 26, 2008 9:48 am
by bikingpro911
if i had a total of 8 5' long 4" sch 40 tanks with two screw caps, one in front an one in the back so i can spray some 3-2-1 dry in so it gets a perfect mixture of air-fuel ratio. and the tanks were all combined together with t's and 4-ways and had a 1.5" sch 40 barrel.
would it be a tank or would it just blow up on me? lol
Posted: Thu Jun 26, 2008 9:50 am
by SpudFarm
it would be not that good.
you would need a long 4" barrel to really use the power potential in it
Posted: Thu Jun 26, 2008 9:58 am
by bikingpro911
ok so then scrap the 1.5" barrel an make it an 2"...is it better? an how long of a barrel would i need cuz some1 told me i need a 60' long barrel? like wtf?
lmao
Posted: Thu Jun 26, 2008 10:09 am
by Carlman
dude you have 40' of 4" PVC for the chamber plus elbows and Ts. now for a 1.5" barrel it would be more than 60'.
i was the one that told him, that was his question that he so had to ask on chat and write it in his thread that asked ppl to go on chat and bloody answer his question.
Posted: Thu Jun 26, 2008 10:14 am
by SpudFarm
4" barrel is a bare minimum on those chambers
Posted: Thu Jun 26, 2008 11:53 am
by pizlo
Its doable it will work, but ignition will be a bitch, and its stupid
Posted: Thu Jun 26, 2008 12:12 pm
by bikingpro911
lmao im just gunna use a stun gun for igntion. the fuel 3-2-1 dry is UN FREAKIN BELIEVABLE. lol its cheep in walmart an powerfull as (word you drop something on your toe) lmao
Re: what would this be like?
Posted: Thu Jun 26, 2008 12:58 pm
by D_Hall
bikingpro911 wrote:so i can spray some 3-2-1 dry in so it gets a perfect mixture of air-fuel ratio.
"spray" and "perfect mixture" should never be used in the same sentence unless the sentence is, "Using a spray and pray gun, it is virtually impossible to get a perfect mixture of fuel and air."
Posted: Thu Jun 26, 2008 3:09 pm
by Carlman
yea man if your set on doing this ridiculous waste of money launcher then go for it, but for christs sake make it metered propane
Posted: Thu Jun 26, 2008 6:08 pm
by psycix
Your launcher will not be powerful since you seem not to have alot of knowledge of spudguns.
A larger chamber does not give an higher pressure, the only performance gain is that you have more air on that pressure, and thus the pressure drop of air going into the barrel will be less. This makes you able to use longer barrels, and thats it.
However, using 40 feet of 4", and your C:B ratio would have to be within 0,5 and 1,5 then you would need a 4" barrel with an length between 27 and 80 feet.
An 2" barrel would have to be even 4 times as long! Not even talking about 1,5".
Furthermore, the time it takes to combust all that gas is enormous unless you've got over 20 spark gaps. If you would use a 5 feet barrel, then using something a 2' 4" chamber would be more powerful then your 8x5' 4" chambers
I would also like to know how you were planning to use an aerosol can for achieving a perfect mix. You WILL need metered propane for this.
would it be a tank or would it just blow up on me?
Why would eight 5' pipes blow up faster then a single 2' pipe? If you use pressure rated parts nothing is going to blow.
Also, due to the huge volume and thus the huge combustion time, it doesn't generate a very spiky pressure peak, so its actually less likely to blow up in that way. On the other hand, the more fittings you have, the bigger the chance there is one that fails due to fabrication errors or improper glueing.
lol
Note that putting that behind your post, and also excessively using the word the word "lmao", makes you look like a retard in some way.
Re: what would this be like?
Posted: Thu Jun 26, 2008 6:31 pm
by starman
bikingpro911 wrote:if i had a total of 8 5' long 4" sch 40 tanks with two screw caps, one in front an one in the back so i can spray some 3-2-1 dry in so it gets a perfect mixture of air-fuel ratio. and the tanks were all combined together with t's and 4-ways and had a 1.5" sch 40 barrel.
would it be a tank or would it just blow up on me? lol
It wouldn't be either...rather a ridiculously non-practical franken-chamber. Unless you had perfectly coordinated spark gaps firing in all the "sub chambers", it would take from now until kindom-come to get all the propane burned out. In the mean time the tater would have left the barrel after only a tenth of one chamber had fired...or so (
)
If you could find a way to efficiently connect to a BIG dia barrel, say 10-16", you might come close to really using the potential...otherwise don't bother.
Posted: Thu Jun 26, 2008 8:50 pm
by SEAKING9006
What are you trying to do, fire a 100-pound shell across the English Channel?
Posted: Fri Jun 27, 2008 5:06 am
by psycix
Even that wont be achieved with this.
Big doesnt always mean more power.