SpudFiles

I was just looking over on www.eBay.co.uk, and i found this....http://cgi.ebay.co.uk/Pro-Quality-Tyre- ... otohosting

Do you think i could modify the end of this to fit a standard Propane Tank.

ChunKy

A reply would have been helpful while the Item was still on Auction...

I was going to answer your question, but then i read your second post in the topic "a reply would have been helpful while the item was still on auction..." and I decided to start my response by telling you how obnoxious you are. The members of the forum dont mind answering questions but they are also not here to spoonfeed you answers to obvious questions. Think about it... is it npt? most likely. Can you thread a torch head? Yes. Can you buy fittings? Does the gauge go to atleast 80 psi? Yes.

The only work to be done to make that work is calculate how much fuel you need according to your chamber, which can very easily be done on burntlatke.com fuel tool section.

Again about how obnoxious your second post is, you cant instantly expect an answer to a question. People dont just wait for you to post so they can answer your question, we have lives we dont just sit in front of the screen waiting for you to post... well pimpmann does but everyone else has better things to do...

Just next time, post a bit more ahead of time, and theres no need for a second post like that.

yea ok, it just got me a little annoyed that i will have to pay out £25 instead of £7, i couldn't find the information anywhere else on this website. So i asked..