Seal up a hole?
Posted: Fri Oct 06, 2006 6:11 pm
Hi im building a combustion spud gun and my retard brother drilled a hole in theh top anyway to seal it safely or do i have to buy more tube?
Page 1 of 1
Posted: Fri Oct 06, 2006 6:17 pm
Posted: Fri Oct 06, 2006 6:25 pm
How big is the hole?
Posted: Fri Oct 06, 2006 8:01 pm
You could use a rubber boat repair thing or put a screw in it and epoxy it up.
Posted: Fri Oct 06, 2006 11:35 pm
JB weld! i used alot of it and have used it to seal pvc pipe, put some duct tape on the side you want the smoothest, and fill er up, then file down or sand if needed. but yeah, jb weld is awesome
Posted: Fri Oct 06, 2006 11:47 pm
how big is the hole?i say tap a screw into it and JB weld it or glue it in as well 8)
Posted: Sat Oct 07, 2006 9:53 am
MrCrowley stole my idea 
lol i have just used to rubber boat repair kits for small holes and if its a bigger one use a bolt/screw with some Epoxy around it and you should be fine small leaks arent a big problem in combustion gun i just put duct tape over a really small whole and that works fine so it all depends on the size of the hole.
Wtf was your brother thinking anyway lol.
lol i have just used to rubber boat repair kits for small holes and if its a bigger one use a bolt/screw with some Epoxy around it and you should be fine small leaks arent a big problem in combustion gun i just put duct tape over a really small whole and that works fine so it all depends on the size of the hole.Wtf was your brother thinking anyway lol.