SpudFiles

hey Guys

well its been a little while since ive been building. Took a bit of a break sold all my cannons too friends. money was very tight. But im building another combustion. Its like a modded version of pete zaria's basic reliable cannon with the propane meter and stuff. Anyways what type of bit should i use to Pilot a hole to hand screw 3/4'' brass nipple to.



THanks
Haylo_stealer

1" Should do the trick if you drill it perfectly streight.

I should be able too so 1'' bit should to it

Yes, the pipe is 1.050" OD.

where can i get a 1" bit and about how much do you think it would put me out.
though im going to rip of lowes anyways. Ill buy it use it refund it.