Electronicaly triggered BBMG
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 345 times
I thought you had given up on us but that more than justifies your absence, brilliant work
hectmarr wrote:You have to make many weapons, because this field is long and short life
A rough guide:kjjohn wrote:I have seen people make these before, and always wanted to make one! How much did it cost you?
$200 for motors
$300 for electronics
$100 for bearings, rod, socket screws etc
$120 for the HDPE used for the gantry and Z Axis
$50 for MDF and odds and sods
$50 for the Ozito router
The software is freeware/shareware and I have lot's of spare PC's lying round here.
I had a mental budget of "under $1000". That may sound a lot but considering a real CNC router is upwards of $6000 just at the entry level its not too bad. Besides which, I made it myself, learned heaps on the way and had a lot of fun.
You can certainly do it cheaper, the original specs that I worked from used all MDF, roller skate bearings and gas pipe rails and had a budget of about $500.