SpudFiles

Well i've been wanting to build a pneumatic single shot gun with a small pump attached. I know that when i put a bb barrel on my big pneumatic and pumped it just two times, from about 10ft it can shoot a airsoft bb through a playing card, fairly accurate.

My ideas are simple, just mod a toy MP5 rifle, cut the stock of, using my chamber as a stock also. It will have a 3/4" Sprinkler valve, i know it will have the sides sticking out, but I'm going to blend them in to make it look like flashlight and accessory's rails.

The top image shows the idea, the blowgun will be modded, and chopped up a bit to fit better, and the trigger will be shortened.

The middle image is another one, just showing about the stock, and how it will look after hopefully after a lot of chopping up.

the bottom image was my original idea, until i thought about casing it in a toy gun. I want to case it because it will look better the a pile or collection of pipes in my cupboard mentioned by someone before about someone else doing this.

EDIT: Btw the drawing were very quick, because i'm watching CSI and thats where i got the MP5 idea from, and i just like MP5's

i was thinking about doing something like this, but with a super soaker, the pump and stuffs already there all it needs is a barrel and to be airtight.


it was gonna be a cloud in disguise

I would suggest doing a vortex cap for this kinda project... just my 2 cents..

Davidvaini wrote:I would suggest doing a vortex cap for this kinda project... just my 2 cents..

Nah ive made one before, and they use a crap load of BB's, and alot of air.

This will just be a little plinker, that fires lead BB's and slugs and what not.