so i've looked through the whole forum practically and found many various ways they were built
some were using pvc, wood and some greyish molding cement [ w.e it is ]
i also realized some people used semi half circles and full ones
my chamber is 1.5"
what would be the best for my gun, to use wood? semi half circle? full??
Posted: Tue Jul 29, 2008 2:17 pm
by trollhameran
Im no expert but I would say it depend on what materials are available to you. If you have access to a wood turning lathe, then use wood, the grey cement is bondo I think, it can be bought at a car repair place, so you could use that.
Posted: Tue Jul 29, 2008 2:18 pm
by nosebleedXD
i don't have any of those blondo so i think i will go with wood
but again, i've seen various ways people built it, which would be best, full circle or semi
Posted: Tue Jul 29, 2008 2:21 pm
by trollhameran
If your going with wood then I would say full circle would be easier to construct.
Posted: Tue Jul 29, 2008 2:22 pm
by nosebleedXD
lol ok thankyou off to basement i am
oh and what would i use to glue the barrel to the vortex block, keep it in place with chamber and everything
Posted: Tue Jul 29, 2008 2:25 pm
by trollhameran
use epoxy, and try to leave as much wood as you can around the hole for the barrel so that it has more surface area to stick to.
Posted: Tue Jul 29, 2008 2:26 pm
by nosebleedXD
and how thick should the wood be
my chamber is only 1.5"
Posted: Tue Jul 29, 2008 2:36 pm
by trollhameran
try and get a square just over 1.5" by 1.5", that should be plenty, make sure you sand the inside of the vortex thoroughly otherwise it wont work
Posted: Tue Jul 29, 2008 4:25 pm
by nosebleedXD
hmm time to go look for a piece of wood, pretty sure i have some around my basement or garage
Posted: Tue Jul 29, 2008 5:36 pm
by blind909
I say half hole. I made a half hole, and it was for a 1 inch chamber, and it was made of redwood.
Posted: Tue Jul 29, 2008 8:35 pm
by nosebleedXD
ok, if you go to this post, i uploaded 2 images that i plan to build
[scroll down]
here is the guy i plan to build
[youtube][/youtube]
Posted: Tue Jul 29, 2008 10:15 pm
by VH_man
why have i never seen that gun before....... its not only ingenious but gorgeous......
I like how the feed spring goes along the barrel, decreasing the size profile of the gun.
ANYWAY, if you follow that gun well, it should work fine. BBMG's are pretty hard to mess up......