Don't tell jsr but i may have to stop using that stuff 
i plan to put it back together with jb weld and give it a go, i might even load it this time 
auto gun 2.0
-
suture self
- Private
- Posts: 13
- Joined: Wed Feb 11, 2009 8:27 pm
ok so here's the refined version that i (crudely) put together, i took jsr's idea for a valve to pulse the air inlet and it ran like a sewing machine for about 5 seconds, then my epoxy let go and the valve exploded across the room Don't tell jsr but i may have to stop using that stuff i plan to put it back together with jb weld and give it a go, i might even load it this time
Don't tell jsr but i may have to stop using that stuff i plan to put it back together with jb weld and give it a go, i might even load it this time - Attachments
-
- note the valve at bottom
How long did you let your epoxy sit ?
Did you roughen up the surface and bit deep grooves in it ?
Those are the two main factors that cause Epoxy to fail
Did you roughen up the surface and bit deep grooves in it ?
Those are the two main factors that cause Epoxy to fail
Note epoxy cure time very important barrels are hard to remove from the wall
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
Or rather, you may have to start using proper stuff properlysuture self wrote:the refined version that i (crudely) put together
Don't tell jsr but i may have to stop using that stuff