Page 1 of 1
barrel?
Posted: Wed Jun 20, 2007 5:37 pm
by bassmaster1228
i was wondering if any1 knew any good materials to make a .177 cal barrel out of and where to get them. help will be much apreciated.
Posted: Wed Jun 20, 2007 5:51 pm
by rednecktatertosser
1/4 inch ridgid aluminum brakeline. from autozone, or the like.
or, a barrel form a broken bb gun
Posted: Wed Jun 20, 2007 5:54 pm
by hi
alluminum arrows.
Posted: Wed Jun 20, 2007 6:01 pm
by bassmaster1228
well i have aluminum arrows but there not small enough and i have carbon arrows and there not small enough. i think i might go with the breakline. is the any way i could make the brakline rifled?
Posted: Wed Jun 20, 2007 6:04 pm
by rednecktatertosser
i think that the brakeline is too small to be rifled. plus it wont have a positive effect on a round projectile, the spin will just make the projectile cut to one direction instead of going straighter
Posted: Wed Jun 20, 2007 6:06 pm
by bassmaster1228
ok i wont woory about rifleing it .... thanks alot guys
Posted: Thu Jun 21, 2007 12:05 pm
by Kenny_McCormic
1/4 inch brakeline is horrible look around hobby shops and hardware stores for brass tubing im going out today to look fora new barrel for my cloud