1st Pen cannon/gun

[Benjg555]

Ohh oops. Ya I know the tire valve is a schrader valve just clarifying I guess.

Thanks though

[Gun Freak]

Alright man thanks ya definetly even I it means drilling out the shredder valve and whatever else is in it . I'm going to start It as soon as possible.

Why would you drill out the schrader valve? Dude it sounds like you don't know what you're doing, a pengun in the wrong hands is not good. Do you have any experience with pneumatics?

[Benjg555]

No no no If I didn't like the way the pengun worked. I'd drill out the schrader from the bb gun barrel so I can save it. Yes a bit I know what too do hehe

Heres a picture of the barrel trimmed and with tire valve on end which fit right around the bb gun barrel haha. Should be around 5 inches when finished

[Crna Legija]

Odd shaped pen

[Gun Freak]

Odd shaped pen

LOL Well not all "penguns" look like a pen, JSR's pengun V.2 for example.

[Benjg555]

Odd shaped pen

LOL Well not all "penguns" look like a pen, JSR's pengun V.2 for example.

Haha true that man. Ya that tire valve isn't going to be that big just an FYI. I'm sanding it down tomorrow.

[Gun Freak]

I use a bench grinder for mine with the schrader clamped in my drill chuck and spin it on the grinder and metal hair part untill it is nice and brassy and shiny.

[Benjg555]

Ohh alright I'm just going to put mine in locking players then stick it into the spinning circle sander until nice and shiny too
I'll put a pic of it tomorrow.

[Gaderelguitarist]

spinning circle sander

Disc Sander?

*facepalm*

[Benjg555]

Haha something like that you'll see it in a picture tomorrow.
Or in a drill press's chuck and as it's wizzing around having a peice rough sandpaper against it.

I use a bench grinder for mine with the schrader clamped in my drill chuck and spin it on the grinder and metal hair part untill it is nice and brassy and shiny.

This is what I used to sand it.


I had a drill press but I didn't use it :/

Here is what the valve looked like afterward.


Sorry the quality is bad. I'll put a better one up tomorrow. I left it at my school :/ .

Edited by jrrdw, double post.

[jrrdw]

Bench/Table sander. Does the table tilt so you can sand at a angle? Looks kinda old, but nice... 8)

[Benjg555]

Oh alright. No it doesn't just stays like that . I do have a bench grinder also (should of used.) ya it's gotta be 4+ years old. But hey it works good it liked to eat the metal on the valve like it was nothing haha.

Thanks :occasion5:

[Gun Freak]

Looks like there is still a bunch of rubber on the valve, get it off so you can stick it all the way in.

[Benjg555]

Yep yep going to do that tomorrow with the bench grinder. The dis sander was eating the brass off of it no joke.