Page 1 of 1
mini maniac
Posted: Sat Jun 14, 2008 12:52 pm
by sniper hero
this is my mini combustion
I made a while ago but it didn't work
today I discovered that the trick is to spray a little bit of axe in it and wait 6 seconds before closing the spray opening and then
shoot 
it shoots a small piece of paper through a whole room.
the barrel is 6mm
the pvc is 32mm OD
Posted: Sat Jun 14, 2008 12:55 pm
by bigbob12345
Well that chamber is a bit overkill but it looks like a fun thing to mess around with.
Posted: Sat Jun 14, 2008 1:10 pm
by STHORNE
well, what works best with minis is to spray your axe in there, then give it a quick blow/puff of air (right into the chamber), then quickly put the cap back on. It should only take you 2-3 seconds or so.
You should also see an increase in performance. Btw, try shooting nails with a bit of electrical tape at the end
Posted: Sat Jun 14, 2008 10:48 pm
by Carlman
nice one mate!
with that chamber you can triple your barel and you would be gining performance, you could even quad it!
Posted: Sat Jun 14, 2008 10:52 pm
by TheTrooper
Like Carlman said your chamber is a lot of overkill, but since you might not be able to extend your barrel its ok.
Whys the barrel so crooked
Posted: Sun Jun 15, 2008 11:46 am
by sniper hero
the barrel is crooked because the cap is thin and the barrel is not deep in the chamber.
I will make a better mini soon