SpudFiles

Hey, im half way through making my 15mm pellet coaxail ive got everything done except some way to make my gun servicable i need something like a 15mm coupler but one side end feed and the other mail threads but im from england so please only mention english sites or places.

Thanks, qwerty

what type of pipe are you using?

15mm copper pipe

I have seen some small copper fittings in my ace shop... You could find a supplier near you... Mcmaster always has the stuff you need but I am not sure how expensive the shipping would be to england... i can find most 1/2 copper fittings in my local homedepot so you might jsut have to do some searching

good luck

http://www.screwfix.com/prods/94310/Plu ... ler-15mm-x there you are it may require some dremel work from what i heard i thought you might need a slip to male coupler

what about somwthing like this http://www.h-i-e.co.uk/acatalog/Endfeed ... Iron_.html

That could work, and you would use a plug to close the back, rather than a cap. The plug (Ideally hex head) would provide more material for the threads for the pilot to bite into (if you tapped them yourself) than a cap, which you would use if you went with male threads.

If you wanted a pre-threaded end plug, you could use a bushing.

I took these guns apart after finding out that a my pistons would not seal but i have a new bb coaxail 3/4 finished out of the same parts.

(just need to wait for my blowgun to arrive)
heres what they did look like for infomation