Free cannons to good home
Posted: Fri May 13, 2016 3:11 pm
It is a sad day but the cost of storage space in the south east of england is rising exponentially but my savings are not, and so I need to go lean on my belongings for a decade or so.
I will be keeping my combustion cannon, but I have:
A a part-built piston pneumatic:
10bar rated PVC, 50mm x 1m chamber, 1/2" female thread barrel port. I have some 50mm and 40mm PVC you can take with you too, to make a barrel.
Pic 1 Pic 2
A finished copper QEV gun. This has 22mm copper tank and barrel, about 1.2m long I guess, nice over-under rifle design. It needs a trigger hooking up. It's a commercial 3/4" valve which is rated for 10 bar but I always used to take it higher.
Valve| Whole cannon
A very unfinished.. thing? It was going to be a water cannon, but then I realised this grip assembly was unnecessary.
Pic
The rest of the water cannon consists of an expansion tank and stainless steel woven hose with a 1/2 ball valve on the end. If you want that too, you can have it.
I would like to ship any or all of this to someone with an interest in the hobby. Ideally they should be able to show a cannon they have already built, but this isn't essential. I just don't want to see £100+ worth of kit get put in someone's attic and then scrapped in a few years.
Buyer covers delivery/collection.
I will be keeping my combustion cannon, but I have:
A a part-built piston pneumatic:
10bar rated PVC, 50mm x 1m chamber, 1/2" female thread barrel port. I have some 50mm and 40mm PVC you can take with you too, to make a barrel.
Pic 1 Pic 2
A finished copper QEV gun. This has 22mm copper tank and barrel, about 1.2m long I guess, nice over-under rifle design. It needs a trigger hooking up. It's a commercial 3/4" valve which is rated for 10 bar but I always used to take it higher.
Valve| Whole cannon
A very unfinished.. thing? It was going to be a water cannon, but then I realised this grip assembly was unnecessary.
Pic
The rest of the water cannon consists of an expansion tank and stainless steel woven hose with a 1/2 ball valve on the end. If you want that too, you can have it.
I would like to ship any or all of this to someone with an interest in the hobby. Ideally they should be able to show a cannon they have already built, but this isn't essential. I just don't want to see £100+ worth of kit get put in someone's attic and then scrapped in a few years.
Buyer covers delivery/collection.