Page 1 of 1
Max PSI?
Posted: Fri Aug 04, 2006 6:50 pm
by chubster
Ok, i have a mini-pneumatic. 1/2" barrel and 1-1/2" tank. What's the max PSI I should safely shoot it?
Posted: Fri Aug 04, 2006 6:53 pm
by Mihlrad
no offense but considering the fact that you dont know how to open a can of cement, 10 psi.
If built right, 120.
Posted: Fri Aug 04, 2006 6:59 pm
by chubster
ok thanx
Posted: Fri Aug 04, 2006 7:33 pm
by benstern
First, did you use sch 40 pressure rated pvc? Next, what valve did you use?
Posted: Fri Aug 04, 2006 7:48 pm
by cannon freak
Its very simple just check the pressure ratings on all parts of the gun and whatever the weakest point is don't go above it, keep a good safety margin, just use common sense.
Posted: Fri Aug 04, 2006 8:20 pm
by djt
if your using an air compressor and its all sch 40, i doubt you can even pump it close to what its rated for. but like cannon freak said...READ THE PIPE!!
Posted: Fri Aug 04, 2006 8:21 pm
by M3NT4L
At 20-30 psi if you dont know what type of pipe it is and or the pressure rating.