SpudFiles

Hello all,
How do I go about a dual ignition with a Bbq lighter. or is it even possible? I think my spark is to small. is that possible?? I have seen these dual spark chambers but I think I would need a better ignition system.
Any ideas??



+ i heard about a battery powerd bbq lighter????
can't find one.

Yes, you can do two gaps with a piezo BBQ sparker.

It doesn't matter how many gaps you have (1 or 50) as long as the TOTAL GAP distance isn't more than about a quarter inch (might be a bit more than that, if you got a good piezo). My cannon has a spark strip with 5 small (fingernail-width) gaps, and a BBQ sparker will jump all 5. Lights up propane just fine.

Just wire the gaps/electrodes in series. Here's a diagram. The "+" should be hooked up to the terminals on the sparker - doesn't matter which one goes where. "---" is wire, "o" are gaps:

+----o---o---o----+

Assigned reading: http://www.bcae1.com/srsparll.htm

Peace,
Pete Zaria.

Hello you,
How does one go about using the search function. or is it even possible? I think my brain is too small. is that possible?? I have seen these searches before but I think I am too dumb to use it.
Any ideas???

+ i heard mods hate idiots????
certainly found one.

WOAH! I would have to say best impersonation yet BC!

Muddyspudman, listen up now. Boy, I say boy, are you listenin boy? Alright boy here we go. Now boy, don't be that guy.