SpudFiles

hey,
im a new member and i am going to make a pnumatic rifle really reall soon!
i was just wondering how is the best way to make a breech loading system for marbles as ammo.

thanks for any help ypu can give me!!!!! please send pics if possible! [/b]

Welcome to the forum.

Have a look here for a breech loading design. For future queries, you might want to use the very efficient search feature this forum offers

welcome to spud file
oh and try remember to post in the right section next time

i find a simple breech is just get a bit of pipe slightly larger than your barrel and drill a hole through both the bit of pipe and your barrel.
now to use just rotate the holes until they line up and u put your ammo in then rotate back to seal up. remember this design isn't completely air tight but a bit of duct tape on the outside of your barrel will help. heres a pic

Another easy way is to drill a hole in the side of a ball valve, so that when it is in the "closed position" you can fit a marble in it and then turn it to put it in the barrel. I don't have any pics but I'll try to find a link.

Here it is:

http://www.spudfiles.com/forums/cool-ne ... t7443.html

And welcome to the forum.

that is a good idea jssizzle, if you do that with a meatal ball valve be sure to get all the shavings out, cause i am pretty sure they have O rings inside and you don't want to wreck thous.

You could cut into the pipe big enough for ammo to fit in the adapt a screw on bottom and get the threaded pipe to slide in and screw on. This one is air tight and its not that much of a hassel to reload with some speed.

Bubba

hey
thanks alot for all your idears i reallt apreciate it!!!

No worrys mate I hope it works out for you.
Good Luck mate

Bubba