paintball setup and damage shots, interchangeable barrels

[Mark256]

this is my basic cannon that i have had for a while but am posting it now because got more barrels. am currently using a 3/4 in. barrel. I have 2 in, 3/4 in, and 1/2 in.
I loaded the cannon up and pumped it to 90 PSI shot the jug and it rolled about 5 times. the paintball went through the front and dented/cracked the back of the jug.

it is my trophy

my cannon

string that makes paintballs not fall in the valve


front of milk jug

front i like cub nothing personal

back of jug bulge

after the paintball went through the front it made a crack and a bulge in the back of the jug

back of jug again

cracked an old child pool(paintball marker has never done that after tons of shots)

[jrrdw]

Thats because after mutible shots the target got weakened and split. Great cannon. Any plans on a paint job?

[iknowmy3tables]

3/4pvc doesn't fit paint balls as well as 3/4cpvc or sch80 nice gun looks sturdy

[Mark256]

i was pretty impressed from the damage of a paintball and 40 PSI seems like it was about 400 FPS because it more then a pantball marker thats why i shoot the cannon at 90 PSI

P.S. anybody know how to make the paintball not roll out of the barrel when you point the cannon down.

[trae08]

inject it with mercury and hold a neodymium magnet on the outside of the barrell?

3/4pvc doesn't fit paint balls as well as 3/4cpvc or sch80 nice gun looks sturdy

i wish i woulda known that 6 hours ago.!!

[potatoflinger]

You could put a small piece of a paper towel in front of the paintball to keep it from rolling out of the barrel. That is a great looking gun too.

[Marco321]

P.S. anybody know how to make the paintball not roll out of the barrel when you point the cannon down.

For marbles i used a slim bit of foam glued into the barrel. I have never shot a paintball so I'm not sure if the small obstruction will break the paintball.

If you make a breach loader, i have seen people place an o-ring over the opening so it blocks the paintball from moving forward, this was on a homemade paintball gun on the website.

EDIT: Nice gun by the way, looks fun to shoot.

[Modderxtrordanare]

P.S. anybody know how to make the paintball not roll out of the barrel when you point the cannon down.

Get lower to the ground instead?

[spud yeti]

P.S. anybody know how to make the paintball not roll out of the barrel when you point the cannon down.

I got this from someone on the forums (cant remember who) and it works great.
Drill a tiny hole in the pipe. Cut some bristles from a toothbrush, put them in the hole. Make sure they go in about 1/3 of the way. Now just hot glue it in. You can experiment with the amount of bristles and the distance they go into the pipe.

Great cannon by the way.

[PinHead]

Alot of paintball guns like Spyders use that same concept... they simply call it a "ball detent". Most of them are just a simple rubber bumper that gets pushed out of the way when the ball goes thru; same thing essentially.

[spud yeti]

Paintball guns use metal half balls with a weak spring that gets pushed back too.

[Mark256]

I put a lining of foam medical tape on the inside of the barrel at the bottom end so when you drop the paintball in it gets lodged perfectly in the foam.

works great.

any other tape probably would have worked too but my mom had foam tape so i used it.

the brush idea seems pretty good too.

[Mark256]

picture of the foam tape lining

[spud yeti]

Yeah, that looks like a decent plan. How thick is the tape?