The Shiny Assassin - Breech Loaded Copper Pneumatic (Comp.)

[LucyInTheSky]

They were real but because the clip was slowed down it sounded more extream, thanks for the replies.

[ProfessorAmadeus]

That is an amazingly powerful cannon!! That easily went through the 1/2 board. over all i give it a 10 out of 10

[LucyInTheSky]

Thanks.

I will get a shot of it going through 1 1/4" board soon.
Whitch it can do, i have tried.

[LucyInTheSky]

This is the silencer I made for my spudgun, it makes me able to shoot it without arousing suspiscion <_< .




This is with the silencer slid backto expose the holes in the barrel, and these are the holes.

[LucyInTheSky]

I have modded my gun yet again, and made the chamber closer to the barrel, looks alot more rifle like now (weird as I started it out wanting it like a shotgun) its now even easier to hold/aim and it was free as I found a bag of fittings at the back of my garage and it had 2 45degree street elbows! The soldering isnt as good as I usually do as I was in abit of a hurry and they were endfeeds and I got a little bit on the outside of the joint. I think I am going to paint it, maybe all black apart from the QEV, Ballvalve, and Blowgun?

[SpudStuff]

Ohhh Super Shiny

[Brian the brain]

Very big improvement!!!
And yes, paint it flat black!!The silencer looks very good too!!

[LucyInTheSky]

I will probly paint it, but am having second thoughts as it is illeagal in the UK and it would look alot more like a real gun painted. But what the hell.

It is quite odd as when I started this I had an Idea of wanting it to be like brians' but it some how just evolved into a sniper rifle type gun, with the bolt action and silencer.

I can take the barrel off from just after the QEV and put my barrel on that only goes up to the end of the chamber with no silencer and it kind of looks like a shotgun, but deffinatly not a sawn off as it is about 5' 3" long.

[LucyInTheSky]

I have decided to put a 3/4" QEV on it within this week (it currently has a 1/2" one). It should fit straight in as I will put thread reducers on all the 3/4" threads to make them 1/2".

EDIT: just bought the QEV should be here tomorro or next day.

[LucyInTheSky]

It is finnished, I have put on the 3/4" QEV and ball valve. And it makes a hell of a difference. It can shoot a bit of plum 100m at 5bar easy.

Here are some photos, They just look the same but the valves are abit bigger.

[Brian the brain]

Now you can give your brother the 1/2 qev!!

[LucyInTheSky]

Well I have modded the gun again, now its shorter and easyer/comfortable to hold. It sort of has a bullpup design as the rear of the gun is used as a stock. I have tested it and it works, reduced the total length of the gun only by about 15cm but because the hand is further forward and you have a stock it feels alot shorter and lighter.
That is 10mm pipe, it might look flimsy but is very sturdy.

[Brian the brain]

Again a real improvement.

[air spud 7]

the clip did not work on my computer but its a nice gun anyway

[MrCrowley]

anymore upgrades???? i saw this cannon at its first design and some how ive missed all the improvements till now