If you're making an air rifle, do you use homemade valves most of the time or do you just buy a valve?
Greetings from the Dutch, Jaffe
Valves... purchased or homemade?
its mostly whatever you prefer. ive seen alot of rifles that use sprinklers and alot that will use pistons. but ive heard that a good rule of thumb is there isnt really non need for a homemade piston or anything unless you go bigger then one inch pipe.then you should make a custom valve.
Marvin the Martian: Where's the kaboom? There was supposed to be an earth-shattering kaboom!
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
PCGUY wrote:Congrats, your the first donating member I have had to ban.
go with a piston or a QEV valve. and in my opinion make the piston valve even if its smaller than 1" they have very good flow and dulp alot of air/gas quickly.
if your not sure what these are spend some time searching the forum and have a look here:
hope it helps.
oh and
greetings from Australia
if your not sure what these are spend some time searching the forum and have a look here:
hope it helps.
oh and
greetings from Australia
