I wouldn't say perfect, but very nice. you should try and make a faster opening valve. the performance boost will surprise youMr.Russ wrote:
THIS GUN IS PERFECT!
Mr.Russ Sniper**UPDATE**
searching for a modern day savior from another place,inclined toward charity,everyone's begging for an answer,without regard to validity,the searching never ends,it goes on and on for eternity
-Bad religion
-Bad religion
it is perfect, for me anyway.
I dont want a faster openiung valve. Everyone suggest sprinklers, but i think theyre too bulky. The pistol grip makes it comfier, and i get about 4 powerful shots out of a tank. it drops 20psi every shot.
I dont want a faster openiung valve. Everyone suggest sprinklers, but i think theyre too bulky. The pistol grip makes it comfier, and i get about 4 powerful shots out of a tank. it drops 20psi every shot.
-
MrCrowley
- Moderator
- Posts: 10078
- Joined: Fri Jun 23, 2006 10:42 pm
- Location: Auckland, New Zealand
- Been thanked: 3 times
Mr.Russ, instead of clogging the blow gun top with hot glue, I found another solution.
I have the same blow gun and what I did was got rid of the guage(it's sh|t, they break fast and are flimsy) and cut the brass fitting of from the base of it.
It has a hole in the top of it, so find a screw that's similar size, thread a hole for it in the brass and then thread the screw in.
Once threaded, cut the top of the screw off and sand it down smooth, then screw the brass fittings into the hole where the guage was and cut the rest that sticks out, then sand it so its nice and smooth.
And your done, only takes like 5 minutes.
I have the same blow gun and what I did was got rid of the guage(it's sh|t, they break fast and are flimsy) and cut the brass fitting of from the base of it.
It has a hole in the top of it, so find a screw that's similar size, thread a hole for it in the brass and then thread the screw in.
Once threaded, cut the top of the screw off and sand it down smooth, then screw the brass fittings into the hole where the guage was and cut the rest that sticks out, then sand it so its nice and smooth.
And your done, only takes like 5 minutes.