barrel?
-
bassmaster1228
- Private 3
- Posts: 42
- Joined: Sun Jun 17, 2007 6:51 pm
- Location: Mobile, Alabama
i was wondering if any1 knew any good materials to make a .177 cal barrel out of and where to get them. help will be much apreciated.
-
rednecktatertosser
- Corporal
- Posts: 590
- Joined: Tue May 22, 2007 7:52 pm
1/4 inch ridgid aluminum brakeline. from autozone, or the like.
or, a barrel form a broken bb gun
or, a barrel form a broken bb gun
Last edited by rednecktatertosser on Wed Jun 20, 2007 5:57 pm, edited 1 time in total.
alluminum arrows.
"physics, gravity, and law enforcement are the only things that prevent me from operating at my full potential" - not sure, but i like the quote
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
-
bassmaster1228
- Private 3
- Posts: 42
- Joined: Sun Jun 17, 2007 6:51 pm
- Location: Mobile, Alabama
well i have aluminum arrows but there not small enough and i have carbon arrows and there not small enough. i think i might go with the breakline. is the any way i could make the brakline rifled?
-
rednecktatertosser
- Corporal
- Posts: 590
- Joined: Tue May 22, 2007 7:52 pm
i think that the brakeline is too small to be rifled. plus it wont have a positive effect on a round projectile, the spin will just make the projectile cut to one direction instead of going straighter
-
bassmaster1228
- Private 3
- Posts: 42
- Joined: Sun Jun 17, 2007 6:51 pm
- Location: Mobile, Alabama
ok i wont woory about rifleing it .... thanks alot guys
current project: portable pnuematic sniper rifle
-
Kenny_McCormic
- Specialist 2
- Posts: 283
- Joined: Wed Jan 03, 2007 8:59 pm
1/4 inch brakeline is horrible look around hobby shops and hardware stores for brass tubing im going out today to look fora new barrel for my cloud